FAQs
AdPower suppresses static electricity in the air cleaner, and increases the air flow rate to the engine, then improver combustion.
* In research conducted at Tokai University's Faculty of Engineering under conditions of 23.5-24.4°C temperature, 51.2-59.2% humidity, and 100.35-100.55kPa atmospheric pressure, the effect of improving the flow of intake air by suppressing static electricity was obtained.
Please stick it on the air cleaner box on the side of the air duct leading to the engine. If there is no place to stick it on the outside of the air cleaner box, please stick it on the inside of the duct or air cleaner box.
The accelerator response feels better. Depending on the condition of the engine, further improvement in engine recovery may be expected.
Because the combustion of the engine is improved, the engine noise and the vibration may be reduced.*
*By improving the flow of intake air through the suppression of static electricity, it is expected that engine performance will improve. However, the effects obtained will vary depending on the environment.
The effectiveness of the static electricity suppression differs depending on the type of car, and is also affected by the environment in which the car is used. For example, the effectiveness may be difficult to notice in rainy weather or when the air conditioning is being used strongly in summer, but the static electricity suppression effect continues to be provided.
The antistatic effect continues even immediately after removal, and the amount of static charge is low.
No, it does not. AdPower improves engine performance by reducing static electricity in the air intake to the engine, so there is no problem even if it is used in combination with various products.
Although there may be some differences depending on the environment and conditions of use, there is a risk that the static electricity suppression effect may decrease due to the product aging. Also, since it is attached with double-sided tape, the period in which the safety of the attached condition can be maintained is 2 years after installation.
Please wipe the installation area clean with a wet wipe before attaching the product. We use a high-spec Japanese double-sided tape.
For new cars, it may be difficult to notice changes in the feeling of the accelerator, but it will continue to suppress static electricity and improve the flow of the intake air.
For safety during installation, we use double-sided tape with a strong adhesive. Therefore, when removing the tape, the adhesive may remain on the surface, so we recommend using a sticker remover, or wiping the surface with a wet towel to remove the tape.
We do not recommend this. If you re-apply the tape, the adhesive strength of the double-sided tape will decrease. Also, when you remove the tape, it may cause wrinkles in the product or affect the material of the product.