3 easy steps

Click here to see the video.

 

　１．Open the hood　

1. Pull the hood opener near the bottom right of the driver's seat.
   
   
   
   
2. Make sure there is a gap in the hood.
   
   
   
   
3. Open the hood further while pulling up the lever near the center of the hood gap.
   
   
   
   
4. Keep with the hood stay.
   
   
   
   
   

  2.　Find the air cleaner   

Find the air cleaner. 
The air cleaner is located near the engine body and is a box with a hose-like air duct.

 3.  Paste      

Remove the double-sided tape on the back of AdPower and attach it over the air cleaner box on the side of the air duct connected to the engine. Wipe the installation area clean with a dry cloth before application for better adhesion. 

POINT

• If the top of the air cleaner box is too rough to install, please install it on the side
  ※ The effect will not change. 
• Please note that once the product has been applied, it is fixed and cannot be reapplied.

 

POINT
If more than two pieces are required, please install them in separate locations.

 

  1.　Finde the air cleaner   

It is near the engine body. Please check the instruction manual of the motorcycle.

 

  2.　Open the air cleaner   

Remove the fastener that secures the lid with a screwdriver, etc., and open the air cleaner.

 

   3.　Just stick it!　 

Peel off the double-sided tape on the back of the AdPower and attach it inside the air cleaner box, on the outside of the air filter (before it passes by). 

*We recommend the space on the upper side, where there is less risk of dirt from blow-by gas, etc.

 

Installation Gallery

We previously recommended installing it on the inside of the air cleaner, but as a result of research carried out at Tokai University's Faculty of Engineering, we now know that installing it on the outside of the air cleaner box has the same effect as installing it on the inside.
Currently, for simplicity of installation, we recommend the installation on the outside of the air cleaner for standard cars. It is not necessary to change to the outside if it is already attached to the inside.

 

Installation Q&A

Here you will find the questions and answers we have received from our customers. Please refer to them when installing the product.

Q: Is there any difference in the effect of applying it inside or outside the air cleaner box?
A: No, it doesn't. The effect is the same. We recommend installing AdPOWER on the outside of the air cleaner box for easier installation.

Q: When installing two pieces, is it better to put them together centrally or at a distance diagonally ( facing each other)?
A: It is better to place them at some distance from each other rather than concentrating them.

Q: For Nissan NV350 caravan, where should I install it? Should I attach it on the cover of the air cleaner or on the body side after removing the air cleaner?
A: We've added the arrows. Please wipe the inside surface clean before installation. For reference, please also see the example of installation on a truck.

 

Q: Is it more effective to install more than one product per vehicle?
A: The accelerator response feels better. Depending on the condition of the engine, a further improvement in engine performance may be possible.

Q: Is it possible for the product to peel off and get sucked in when attached to the inside of the air cleaner?
A: There is no such problem. The product is less than 1 mm thick when installed. The high adhesive double-sided tape adheres to the entire surface of the constituent material, making it extremely difficult for this to happen and we have no experience of this happening. 

Q: I currently attach it on the inside, should I change it to the outside?
A: The effect is the same, so you do not need to change.